Installing rainwater harvesting systems can provide a variety of benefits, financial as well as reducing the risk of flooding in some areas.

However, it may not be suitable for every installation, and needs some careful thought and assessment beforehand before committing to any expenditure.

Rainwater harvesting is very simple, and has been practiced for centuries.  Rainwater is collected from a clean surface (i.e. a roof), filtered, stored and reused.  It is a system used by millions of people around the world who don’t have access to a mains water supply.  In Germany, harvesting rainwater is widely practised with approximately 60,000 systems installed a year.

In the UK, rainwater harvesting is not so straightforward, and depends upon the location and end use.  The financial benefits depend upon the cost of the mains water which is relatively cheap compared to parts of continental Europe.

To establish whether a rainwater harvesting system will benefit your residence or business follow the basic steps set out below:

1.  Quantify the amount of water you currently use
– simply done by checking recent water bills

2. Quantify the maximum water you can harvest in a year
– based upon rainfall in your area, the area at the installation (house or business) over which it can be collected.

Annual rainwater yield (Y) in m3 = P x A x 0.8

Where P = annual precipitation (in metres) and A = collection area (m2)

0.8 = typically you should expect to collect approximately 80% of this water each year, due to small losses in filtering and small rainfalls that do not generate enough run-off.

3. Quantify the cost
Check water bills to assess current cost, and possible saving

Water quality is an important consideration depending upon the reuse application. Water for general domestic use such as WC flushing or irrigation of gardens, can be of a lower quality than that required for any application relating to food processing etc.

The table below illustrates the amount of water you could save, based upon the collection area.

A guide on the amount of water you could expect to save save, based upon the collection surface area

A guide on the amount of water you could expect to save save, based upon the collection surface area

Advertisements

About thewastewaterman

Chartered civil engineer with 30+ years' experience, specialising in the treatment and management of waste water. Expertise includes rainwater harvesting, water recycling, natural wastewater, reed beds, drainage, stormwater management (SuDS) and sludge/slurry

2 responses »

  1. […] Reducing reliance on mains water with rainwater harvesting (wastewaterexpert.co.uk) […]

  2. […] Reducing reliance on mains water with rainwater harvesting […]

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s